- This topic has 4 replies, 2 voices, and was last updated February 20, 2024 at 8:33 am by Brad Weeks.
-
Posts
-
Hello,
I recently upgraded my firmware for m1g and it dropped all the previous settings.
I added all sensors but with garage door sensor (sentrol magnetic contact + 2 way transmitter with temper (has a spring inside on top of a button). It’s an old sensor with metal jacket around the wire.
I add it from the keypad or the RPK software with the option 1/2 and loop 2 and definition (normally closed). It is added in zone 19.
it keeps “violating “ exactly after one hour. Any idea ?
Brad Weeks
What is the model of your ELK M1 Wireless Receiver to support the GE 319.5 Mhz sensors. What is the model of the sensor?
Brad WeeksFrom the ElkRP2 Software and the Send/Rcv, Enroll/Update Control and Devices screen make sure the model is the M1XRFEG and not the M1XRF2G receiver to support the GE/Interlogix 319.5 MHz Frequency sensors. If it is the M1XRF2G then you will need to rollback to Firmware 5.2.10 . If you confirm it is the M1XRFEG check under Wireless Setup OPT1 should be checked , OPT 2 should be checked and the LOOP Set to 0
- You must be logged in to reply to this topic.