› M1 Support Forum › Setting Counter Causes System Reset

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • April 8, 2021 at 3:04 pm #5104
    Jeff

      Following Rules are causing ElkM1 to Reset:

      WHENEVER EVERY 1 MINUTE

      AND NoMotion_B (Counter 10) IS GREATER THAN 0

      THEN SUBTRACT 1 FROM NoMotion_B (Counter 10)

       

      WHENEVER NoMotion_B (Counter 10) CHANGES TO )

      THEN SET TestCntr (Counter 12) TO 0

      The M1 resets whent the 2 rule executes. If the 2nd rule is disabled, no issue. I’ve tried varations of this rule, such as setting to TestCntr to 1 and adding to TestCntr but reset still occurs.

      April 8, 2021 at 6:42 pm #5105
      Jeff

        Correction due to typo above:

        WHENEVER NoMotion_B (Counter 10) CHANGES TO 0

        THEN SET TestCntr (Counter 12) TO 0

         

        Variations of the above that I have tried, all result in Elk resetting:

        WHENEVER NoMotion_B (Counter 10) CHANGES TO 0

        THEN SET TestCntr (Counter 12) TO 1

         

        WHENEVER NoMotion_B (Counter 10) CHANGES TO 0

        THEN SET TestCntr (Counter 12) TO 1

         

        WHENEVER NoMotion_B (Counter 10) CHANGES TO 0

        THEN ADD 1 TO TestCntr (Counter 12)

         

        WHENEVER NoMotion_B (Counter 10) CHANGES TO A VALUE LESS THAN 1

        THEN SET TestCntr (Counter 12) TO 0

         

        April 8, 2021 at 7:55 pm #5106
        Jeff

          Also tried:

          WHENEVER NoMotion_B (Counter 10) CHANGES TO A VALUE LESS THAN 1

          THEN SET TestCntr (Counter 12) TO 60

          The reason I did this, is becuase I have a similar rule elsewhere that works just fine?!? Thought maybe the set-to value might be the issue. Still, it cause the Elk to reset.

          Here’s the other weird thing: Even if I don’t change the programming, when I connect or do a “check for conflicts” ElkRP reports there are conflicts in the Rules & Texts. There nothing in the Texts. If Select All, and Send checked items to system it behaves as expected. But, on re-connection, ElkRP reports a conflict Rules & Texts (even though there were no changes. “View Difference for selected Items” reports “[Selected Item] cannot be compared.”

          I then tried to Receive All, but that scrambled my new rules with some old rules that I had deleted. Cleared all rules and counters, Sent All. Then, Sent All from a back-up of my account but that results in same issues above.

           

           

          April 13, 2021 at 9:02 am #5117
          Jeff

            Any idea what might be causing this behavior?

            September 10, 2023 at 7:24 pm #7285
            Jarek Bicki

              I would only suggest changing the Whenever statement to 60s instead of 1 min in rule 1

              September 11, 2023 at 4:50 pm #7305
              Brad Weeks

                Are you running M1 Firmware 5.3.18?

              • Author
                Posts
              Viewing 6 posts - 1 through 6 (of 6 total)
              • You must be logged in to reply to this topic.
              Scroll to Top